CN Brand Atus/Aotuoshi Hyraulic Pumps and Motors Manufacturer

 Variable Displacement Piston Pumps Series ATUS PAVC ATUS-PAVC series model specifications are: 33/38/65/100. Brief Introduction: > Pressure compensation > L oad sensing >   Power (torque) limitation >   Power and Load Sensing >   Remote pressure compensation >   Maximum displacement adjustable stop iron >   Electro-hydraulic flow and pressure control >   Low voltage standby >   Working pressure: maximum pressure 207ba >   Speed ​​range: 500-3000r Installation:       When an ATUSPAVC series pump is installed above the liquid level, the position of "control leakage" is not restricted, but the oil inlet must not be at the bottom (PATUSPAVC 100). When an ATUSPAVC series pump is installed below the liquid level, the location of all ports is unrestricted, and the "control leak" should have a separate pipe to the tank and extend below the liquid level, as far away from the oil inlet line as possible...

 Use of hydraulic motors / Precautions 1: The speed of the hydraulic motor should not be too low; 2: The shaft end of the hydraulic motor should be prevented from bearing radial force; 3: The installation direction of the hydraulic motor drain pipe should be upward; 4: The oil drain port of the hydraulic motor should be connected back to the oil tank separately; 5: The hydraulic motor started with load should be careful and avoiding overloaded; 6: Hydraulic motors that remain in the braking state for a long time must use the brake; 7: When starting the hydraulic motor, the viscosity of the working medium should not be too high or too low; 8： When the plunger motor is used for the first time, the casing should be filled with working medium； 9：The oil outlet of the inner curve hydraulic motor should have a back pressure of 0.5~1MPa； 10： In the closed hydraulic motor circuit, there should be necessary measures to ensure that the flow matching is...